![]() ![]() You can use the Available range as a guide, but select a “from” address above the default gateway. ![]() To configure a DHCP server, select Services >DHCPv4>(WiFi interface) from the left column menu.Now WiFi should be up and running, but we need to conveniently hand out IP address and allow access outside the firewall to the internet! Interface Configuration 2 Configuring DHCP and Firewall Rule Select Save at the bottom, then Apply Changes at the top right.“WPA Pairwise” should be changed to the recommended AES.Change “Authentication” to Shared Key Authentication.For WPA mode, we recommend selecting WPA2.Enter a secure password in the WPA Pre-Shared Key field.Our WiFi kits have B/G available in OPNsense. Under common wireless configuration, select the wireless standard you wish to utilize.We used 192.168.10.1 with a subnet mask of 24 for this example Under Static IPV4 configuration, assign an IP address of your choice.Select Static IPv4 as IPV4 Configuration Type.Check Enable Interface to display additional options ![]() You should now be in the interface configuration menu.Once the interface is assigned, select the interface the wireless device is assigned to.select the “+” button to assign it and save run0_wlan1 should be available as a New interface.Back to the Interfaces menu, select Assignments. ![]() The interface run0_wlan1 should be displayed as seen below.Select run0() as the Parent interface and save.In the Devices menu, select Add in the top right corner.Under the interfaces column, select Wireless, then Devices.From the OPNsense web interface dashboard, select Interfaces on the left column.Verify the Vault is powered on and OPNsense is up and running.This section will cover adding the wireless device and assigning it an interface. Protectli Vault with WiFi Kit installed.This includes interface assignment, interface configuration, a DHCP server, and firewall rule. This article covers configuring the Protectli WiFi Kit in Access Point Mode for OPNsense. How to Configure a WiFi module in OPNsense ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |